Canon CLC 1120 Service Manual page 443

6) Remove the coupling [5] and the E-ring
[6]; then, detach the pulley cover [7].
7) Remove the two screws [8] and the cable
fixing plate [9] on the left side; then,
detach the lifter cable [10] on the outside.
8) Remove the two screws [11] and the cable
fixing plate [12] on the right side; then,
detach the lifter cable [13] on the inside.
9) To remove the lifter cable [13] from the
pulley [14] on the inside, remove the two
set screws [16] of the pulley [15] on the
outside to detach the pulley [15] on the
outside in advance.
5. Removing the Lifter Cable (deck
rear)
1) Open the compartment of the deck, and
remove all copy paper.
2) Remove the screw, and detach the paper
rear end guide plate of the compartment.
3) Push the sensor lever [1] of the paper
supply position inside the compartment to
lower the lifter so that the left and right
holes in the compartment side plate and
the left and right holes in the lifter match;
then, insert two long screwdrivers [2]
through the holes. At this time, try
matching the top face of the lifter against
the scribe line on the compartment left
side plate to facilitate the work.
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 PAPER DECK
[16] [10]
[8] [9] [14] [15]
Figure 10-330
[1]
Figure 10-331
[13]
[12] [11]
[7]
[6]
[5]
[2]
10-31