Canon CLC 1120 Service Manual page 224

CHAPTER 6 IMAGE FORMATION SYSTEM
4) Select FUNCTION>INSTALL in service
mode.
5) While keeping the plastic bag against the
discharge opening, press RECV-M/C/Y/
K in service mode (selected according to
the color of the developer to replace).
· When developer stops pouring out,
press the Stop key to end the operation.
6) Fit the cap to the discharge opening.
7) Remove the screw, and detach the
developing assembly.
· To remove the M/Y/C developing
assembly, disconnect the connector
also.
8) Remove the cap from the discharge
opening, and turn the gear by hand while
tilting the developing assembly so as to
remove all remaining developer.
Tilt the developing assembly farther and
farther while turning the gear, ultimately
holding it upright.
9) Fit the cap to the discharge opening.
10) Mount the developing assembly to the
copier.
11) When the copier ends the wait-up period,
select FUNCTION>INSTALL in service
mode.
12) Press SPLY-M/C/Y/K (according to the
color of developer you have replaced).
13) The developing assembly will be locked
in position, and the screw inside it will
start to rotate. (about 10 sec)
14) Fit the developer supply funnel that comes
with the copier against the supply opening
of the developing assembly.
6-72
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 6-648
Figure 6-649