Canon CLC 1120 Service Manual page 462

CHAPTER 11 INSTALLATION
9) Press the release button, and slide out all
the cassettes and the duplexing tray
(CLC1150); then, open the waste toner
collection case cover.
Remove the two screws, and detach the
handle found at the left front (bottom);
then, fit it to the screw hole found to the
right of the waste toner collection case
using the removed screws. (You will be
using the handle when relocating the
copier.)
10) Set the waste toner collection case.
· Be sure that the plastic bag is dilated.
11) Remove the fixing member and the fixing
tape from inside the cassette.
Caution:
Be sure to remove the packaging material
before turning on the power switch.
12) Fit the size rolls that come with the copier
from within the cassette so that the hole of
the marking A (STMT-R) and the hole of
the marking H (LTR-R) are out of view.
(The rolls are used to prevent the use of
inch-configured paper.)
· Be sure that the roll is in even contact.
· As many as three rolls are provided.
Use one as a spare.
Caution:
The foregoing step is intended for a user
not using inch-configured paper.
13) Close the waste toner collection case
cover, and slide all cassettes and the
duplexing tray (CLC1150 only) into the
copier.
11-8
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Screws
Figure 11-208