Processor Pcb (Ip-Main Ip-Ed, If, Ip-Eco) - Canon CLC 1120 Service Manual

3. Removing the Image Processor
PCB (IP-MAIN, IP-ED, IF, IP-ECO)
1) Remove the delivery upper cover.
2) Remove the two screws [1], and detach
the image processor PCB cover [2].
3) If the IP-ED or IF PCB is installed,
remove the two screws [3] and detach the
interface harness trainer [4]. (You need
not perform this step when removing the
IP-ECO.)
4) Remove the two screws from both ends of
each PCB; then, shift up the levers on both
ends to detach the image processor PCB.
COPYRIGHT © 1999 CANON INC. CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 4 IMAGE PROCESSING SYSTEM
Figure 4-508
[3]
Figure 4-509
[2]
[1]
[4]
4-19