Multifeeder; Removing The Multifeeder Assembly; Removing The Pickup Roller, Feed Roller, And Separation Roller; Assembly - Canon CLC 1120 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
B. Multifeeder
1. Removing the Multifeeder

Assembly

1) Remove the right middle cover, right front
cover, right rear cover, right rear face
cover, and right front face cover.
2) Disconnect the two connectors [1], and
remove the four screws [2]; then, detach
the multifeeder assembly [3].
2. Removing the Pickup Roller, Feed
Roller, and Separation Roller
1) Remove the right middle cover.
2) Remove the two screws [1], and detach
the pickup roller cover [2].
3) Remove the resin E-ring [3], and pull out
the pickup roller [4] slowly (both front
and rear).
Caution:
The pickup roller is secured in position
to the shaft with a parallel pin. Take
good care not to drop the pin when
removing or mounting it.
7-60
COPYRIGHT © 1999 CANON INC.
[1]
CANON CLC1120/1130/1150 REV.0 MAR. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[3] [2]
[2]
[2] [2]
Figure 7-729
[2]
Figure 7-730
[4]
Figure 7-731
[1]
[1]
[3]