References; Before You Begin; Configuring Static And Dynamic Igmp Interfaces - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.0.x Multicast Routing Configuration Guide

References

For more information about IGMP, see the following resources:

Before You Begin

You can configure IGMP on IPv4 multicast interfaces.
For information about IPv4 multicasting, see "Configuring IPv4 Multicast" on page 3.
For information about configuring IP interfaces, see Configuring IP in the JUNOSe IP,
IPv6, and IGP Configuration Guide. For information about configuring IPv6 interfaces,
see Configuring IPv6 in the JUNOSe IP, IPv6, and IGP Configuration Guide.
For information about configuring multicast on IPv6 interfaces, see "Configuring
IPv6 Multicast" on page 147.

Configuring Static and Dynamic IGMP Interfaces

The router supports static and dynamic IGMP interfaces. Unlike static interfaces,
dynamic interfaces are not restored when you reboot the router. For some protocols,
dynamic layers can build on static layers in an interface; however, in a dynamic
IGMP interface, all the layers are dynamic. See Figure 6 on page 47 for examples of
static and dynamic IGMP interfaces.
46

References

IGMP-based Multicast Forwarding (" IGMP Proxying"
) draft-ietf-magma-igmp-proxy-00.txt (May 2002 expiration)
RFC 2236 Internet Group Management Protocol, Version 2 (November 1997)
RFC 2933 Internet Group Management Protocol MIB (October 2000)
RFC 3292 General Switch Management Protocol (GSMP) V3 (June 2002)
RFC 3376 Internet Group Management Protocol (October 2002)
GSMP extensions for layer2 control (L2C) Topology Discovery and Line
Configuration draft-wadhwa-gsmp-l2control-configuration-00.txt (July 2006
expiration)