Configuring The Web Interface Proxy (Web Interface); Figure 38 Web Settings Page Detail (Web Ui Configuration) - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller Administrator's Guide
Figure 38 Web Settings Page Detail (Web UI Configuration)

Configuring the Web Interface Proxy (Web Interface)

Configure the Web interface proxy, if needed. See
To set parameters for the Media Flow Controller Web interface when proxied:
1. Enter this information to the text boxes:
• Web Proxy address—Specify a proxy to be used for any HTTP or FTP downloads.
• Web Proxy port—If no port is specified, the default is 1080.
• Authentication type—Configure the type of authentication to be used with a Web
proxy; either None or Basic.
• Basic auth username—If your authenticating with Basic HTTP authentication, enter
a username and a ...
• Basic auth password for that user.
2. Click Apply to complete operation; Cancel to revert to existing configuration.
3. Click Save at the top of the page to make changes persistent across reboots.
Media Flow Controller Configuration Tasks (Web Interface)
Figure 39.
Configuring the Web Interface Proxy (Web Interface) 159