Modules; Introducing The Cisco Intrusion Detection System Network Module - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Modules

Modules
Introducing the Cisco Intrusion Detection System Network
Module
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
1-12
This section describes the modules and contains the following topics:
•

Introducing the Cisco Intrusion Detection System Network Module,

page 1-12
• Introducing the Cisco Catalyst 6500 Series Intrusion Detection System
Services Module, page 1-14
The Cisco Intrusion Detection System Network Module (NM-CIDS) integrates
the Cisco IDS functionality into a branch office router. With the NM-CIDS, you
can implement full-featured IDS at your remote branch offices. You can install the
NM-CIDS in any one of the network module slots on the Cisco 2600, 3600, and
3700 series routers. The NM-CIDS can monitor up to 45 Mbps of network traffic.
See Software and Hardware Requirements, page
routers. Only one NM-CIDS is supported per router.
shows the IDS router in a branch office environment.
Chapter 1 Introducing the Sensor
7-2, for a list of supported
Figure 1-4 on page 1-13
78-15597-02