Gathering Information
show interfaces Command
show interfaces Command
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
B-64
sensor# show statistics Logger
The number of Log interprocessor FIFO overruns = 0
The number of syslog messages received = 120
The number of <evError> events written to the event store by severity
Fatal Severity = 0
Error Severity = 0
Warning Severity = 120
TOTAL = 120
The number of log messages written to the message log by severity
Fatal Severity = 0
Error Severity = 0
Warning Severity = 0
Timing Severity = 0
Debug Severity = 3
Unknown Severity = 189
TOTAL = 192
The show interfaces command is useful for gathering information on the sensing
and command and control interfaces.
This section contains the following topics:
•
show interfaces Command, page B-64
show interfaces Command Output, page B-65
•
You can learn the following information from the show interfaces command:
•
Whether the interface is up or down
Whether or not packets are being seen, and on which interfaces
•
Whether or not packets are being dropped by SensorApp
•
•
Whether or not there are errors being reported by the interfaces that can result
in packet drops
Appendix B
Troubleshooting
78-15597-02