Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 108

Installing the IDS-4235 and IDS-4250
Caution We recommend that you use the dual serial communication cable included in the
accessory kit, because some keyboards and monitors are incompatible with the
appliance.
Note
Step 4 Attach the network cables.
•
•
•
•
•
Power on the appliance.
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-10
You can use a 180/rollover or straight-through patch cable to connect the
appliance to a port on a terminal server with RJ-45 or hydra cable
assembly connections. Use a M.A.S.H adapter (part number 29-4077-02)
to connect the appropriate cable to a port on the terminal server. See
Setting Up a Terminal Server, page
a terminal server.
PCI expansion card slots
Sensing interface: 4250-SX: int2
int0 is the sensing port.
int1 is the command and control port.
int2 is the optional SX (fiber NIC) sensing port.
int2 and int3 are the optional XL card sensing ports.
int2 through int5 are the optional 4FE card sensing ports.
Chapter 5 Installing the IDS-4235 and IDS-4250
1-9, for the instructions for setting up
4250-XL: int2, int3
4250-4FE: int2, int3, int4, int5
Command and Control
interface: int1
Sensing interface: int0
78-15597-02