Recovering The Application Partition Image - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI

Recovering the Application Partition Image

Note
Note
Step 1
Step 2
Step 3
Step 4
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
You can recover the application partition image for the appliance if it becomes
unusable. Using the recover application-partition command, you can reinstall
the original factory image that resides on the recovery partition.
If you have upgraded your recovery partition to the most recent version before you
recover the application partition image, you can install the most up-to-date
software image. See Upgrading the Recovery Partition Image, page
the procedure for upgrading the recovery partition to the most recent version.
You can also use the recovery/upgrade CD to reinstall both the recovery and
application partitions. See
page 9-9, for the procedure.
To recover the application partition image, follow these steps:
Log in to the sensor CLI.
Enter configuration mode:
sensor# configure terminal
Recover the application partition image:
sensor(config)# recover application-partition
You are asked whether you want to proceed.
All configuration changes except for the network settings will be
reset to default. Continue with recovery?
Type yes to continue.
The application partition is reimaged with the original factory image from the
recovery partition. You must now initialize the appliance with the setup
command. See Initializing the Sensor, page
Using the Recovery/Upgrade CD with the Appliance,
10-2, for the procedure.
Reimaging Appliances and Modules
10-112, for
10-111