Installing The Nm-Cids; Specifications; Software And Hardware Requirements - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Software and Hardware Requirements

Software and Hardware Requirements
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
7-2
Table 7-1 NM-CIDS Specifications (continued)
Specification
Nonoperating temperature
Humidity
Operating altitude
The NM-CIDS has the following software and hardware requirements.
The NM-CIDS supports the following software:
Cisco IOS software 12.2(15)ZJ or later
•
• Cisco IOS software 12.3(4)T or later
• Cisco IDS software 4.1 or later
Do not confuse Cisco IOS IDS (a software-based intrusion-detection application
that runs in the Cisco IOS) with the IDS that runs on the NM-CIDS. The
NM-CIDS runs Cisco IDS version 4.1. Because performance can be reduced and
duplicate alarms can be generated, we recommend that you do not run Cisco IOS
IDS and Cisco IDS 4.1 simultaneously.
The NM-CIDS supports the following feature sets:
IOS IP/FW/IDS
•
• IOS IP/FW/IDS PLUS IPSEC 56
IOS IP/FW/IDS PLUS IPSEC 3DES
•
IOS IP/IPX/AT/DEC/FW/IDS PLUS
•
• IOS ENTERPRISE/FW/IDS PLUS IPSEC 56
IOS ENTERPRISE/FW/IDS PLUS IPSEC 3DES
•
• IOS Advanced Security
IOS Advanced IP
•
IOS Advanced Enterprise
•
Chapter 7
Description
–40° to 185°F (–40° to 85°C)
5% to 95% noncondensing
0 to 10,000 ft (0 to 3,000 m)

Installing the NM-CIDS

78-15597-02