Ip Logging - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Configuration Tasks
Step 10
Step 11
Step 12
Step 13
Step 14

IP Logging

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-50
View your changes:
sensor(config-vsc-virtualSensor-ATO-sig)# show settings
The settings for this signature are displayed. In the example above, the settings
for the destination port parameter would appear as
.
2140
To return any value to the default setting, type the keyword default before the
parameter name.
For example, to return the destination port to 2140 (the default value), type the
following command:
sensor(config-vsc-virtualSensor-ATO-sig)# default dstport
The port value is returned to the default value and settings for the destination port
parameter appear as
DstPort: 2140 <defaulted>
Exit tuning mode for this signature:
sensor(config-vsc-virtualSensor-ATO-sig)# exit
sensor(config-vsc-virtualSensor-ATO)# exit
sensor(config-vsc-virtualSensor)# exit
Apply Changes?:[yes]:
Type yes to apply the changes.
The
Processing config:
Exit virtual sensor configuration mode:
sensor(config-vsc)# exit
sensor(config)#
You can manually configure the sensor to capture all IP traffic associated with a
host you specify by IP address. You can specify in minutes how long you want the
IP traffic to be logged at the IP address, and/or how many packets you want
logged, and/or how many bytes you want logged. The sensor stops logging IP
traffic at the first parameter you specify.
Chapter 10
message is displayed.
Configuring the Sensor Using the CLI
DstPort: 2139 default:
.
78-15597-02