Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 53

Chapter 2 Installing the IDS-4210
Note
Attach the network cables.
Step 4
AC power
Mouse
(unused)
Keyboard
•
•
Upgrade the memory on the appliance.
Step 5
See
Caution You must upgrade the memory on the IDS-4210 to a minimum of 512 MB before
you can install the most recent Cisco IDS software version.
Power on the appliance.
Step 6
Step 7 Initialize your appliance.
See
Upgrade your appliance to the latest Cisco IDS software.
Step 8
See
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
You can use a 180/rollover or straight-through patch cable to connect the
appliance to a port on a terminal server with RJ-45 or hydra cable
assembly connections. Use a M.A.S.H adapter (part number 29-4077-02)
to connect the appropriate cable to a port on the terminal server. See
Setting Up a Terminal Server, page 1-9
a terminal server.
Command
and Control
interface: int1
COM1
Sniffing
USB
(unused) interface: int0
int0 is the sensing port.
int1 is the command and control port.
Upgrading the Memory, page
Initializing the Sensor, page
Obtaining Cisco IDS Software, page
for the instructions for setting up
Video
2-3, for the procedure.
10-2, for the procedure.
9-1, for the procedure.
Installing the IDS-4210
2-7