Viewing Signature Engine Parameters - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI
Step 7
Step 8
Step 9
Step 10

Viewing Signature Engine Parameters

Step 1
Step 2
Step 3
Step 4
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
DestAddrs—Destination addresses of events to which this filter should be
•
applied. You can use one of the DMZ or USER-ADDR variables if you
defined them. If you use a variable, you must use a dollar sign
($USER-ADDRS1) in front of the variable. See
System Variables, page
View your changes:
sensor(config-acc-virtualAlarm-eve)# show settings
The settings for the filters are displayed.
Exit event filter submode:
sensor(config-acc-virtualAlarm-eve)# exit
sensor(config-acc-virtualAlarm)# exit
Apply Changes?:[yes]:
Type yes to apply the changes.
The
Processing config:
Exit the alarm channel configuration mode:
sensor(config-acc)# exit
sensor(cofig)#
You can display settings for individual signature engines.
To view signature engine settings, follow these steps:
Log in to the CLI using an account with administrator or operator privileges.
Enter configuration mode:
sensor# configure terminal
Enter service virtual sensor configuration mode:
sensor(config)# service virtual-sensor-configuration virtualSensor
Enter tune micro-engines mode:
sensor(config-vsc)# tune-micro-engines
10-35, for more information.
message is displayed.
Sensor Configuration Tasks
Configuring Alarm Channel
10-39