Removing And Installing The 4Fe Card; Removing The 4Fe Card - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 3 Installing the IDS-4215

Removing and Installing the 4FE Card

Warning
Caution

Removing the 4FE Card

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when installing and removing the 4FE
card.
You can order the IDS-4215 with the 4FE card already installed or you can
upgrade your IDS-4215 with the 4FE card to have four additional interfaces.
This section contains the following topics:
• Removing the 4FE Card, page 3-25
Installing the 4FE Card, page 3-27
•
To remove the 4FE card, follow these steps:
Log in to the CLI.
Prepare the appliance to be powered off:
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note You can also power down the sensor using IDM or IDS MC.
Power off the appliance.
Remove the power cord and other cables from the appliance.
Place the appliance in an ESD-controlled environment.
Removing and Installing the 4FE Card
3-25