Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 68

Rack Mounting
top with the heaviest component at the bottom of the rack. If the rack is provided
with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack.
If you are installing the 4FE card in the IDS-4215, do not install the mounting
brackets until after you have installed the 4FE card.
You must remove the chassis cover of the IDS-4215 to properly install or remove
Note
the 4FE card. See
information on how to remove and replace the chassis cover. See
4FE Card, page
To rack mount the IDS-4215, follow these steps:
Use the supplied screws to attach the bracket to the appliance.
Step 1
You can attach the brackets to the holes near the front of the appliance.
Step 2 Attach the appliance to the equipment rack.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-8
Removing and Replacing the Chassis Cover, page
3-27, for information on installing the 4FE card in the IDS-4215.
C I S C O
I D S - 4 2
1 5
In tr u si o
n D et ec
ti o n S en
so r
Chapter 3 Installing the IDS-4215
3-12, for
Installing the
78-15597-02