Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 228

Sensor Administrative Tasks
The following parameters are optional:
Step 3 View the output on the screen:
sensor# show tech-support page
The system information appears on the screen, one page at a time. Press the space
bar to view the next page or press Ctrl-C to return to the prompt.
To send the output (in HTML format) to a file, follow these steps:
Step 4
a.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-32
page—Displays the output, one page of information at a time.
•
• password—Leaves passwords and other security information in the output.
destination—Indicates the information should be formatted as HTML and
•
sent to the destination that follows this command. If you do not specify this
parameter, the output appears on the screen.
• destination-url—Indicates the information should be formatted as HTML.
The URL specifies where the information should be sent.
Type the following command, followed by a valid destination:
sensor# show tech-support destination-url
You can specify the following destination types:
• ftp:—Destination URL for File Transfer Protocol (FTP) network server.
The syntax for this prefix is
ftp:[[//username@location]/relativeDirectory]/filename
ftp:[[//username@location]//absoluteDirectory]/filename
• scp:—Destination URL for the Secure Copy Protocol (SCP) network
server. The syntax for this prefix is
scp:[[//username@]location]/relativeDirectory]/filename
scp:[[//username@]location]//absoluteDirectory]/filename
For example, to send the tech support output to the file
/absolute/reports/sensor1Report.html
sensor# show tech support dest
ftp://csidsuser@10.2.1.2//absolute/reports/sensor1Report.html
The prompt appears.
password:
Chapter 10 Configuring the Sensor Using the CLI
, type the following command:
or
.
or
.
78-15597-02