Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 50

Upgrading the Memory
See
Step 6 Remove the chassis cover by unscrewing the screw(s) on the front of the cover and
sliding the cover straight back.
Note
Locate the DIMM sockets and select an empty DIMM socket next to the existing
Step 7
DIMM.
Note
Step 8 Locate the ejector tabs on either side of the DIMM socket. Press down and out on
tabs to open the slot in the socket.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
2-4
Working in an ESD Environment, page
IDS-4210 sensors have a single screw on the front cover. IDS-4220
sensors have three screws spaced evenly across the front cover.
On IDS-4210 sensors, the existing DIMM is installed in socket 0. The
angled position of the DIMM sockets make installing an additional
DIMM in socket 1 difficult if a DIMM occupies socket 0. Therefore, you
should first remove the existing DIMM from socket 0, place the new
DIMM in socket 1, and then place the existing DIMM back in socket 0.
DIMM
Chapter 2 Installing the IDS-4210
1-21, for more information.
78-15597-02