Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 59

Chapter 2 Installing the IDS-4210
To install the front mount brackets, follow these steps:
Make sure the appliance is turned off and is not plugged in to an electrical outlet.
Step 1
Step 2 Use the screws provided to attach one chassis support bracket to each side of the
appliance. Use three screws on each side.
Step 3 Use the screws provided with the rack to attach the rack mounting brackets to the
rack.
Step 4 Slide the chassis support brackets on the appliance into the rack mounting
brackets attached to the rack.
Step 5 Use the bolts provided with the rack to fasten the appliance's front flanges to the
rack.
Note
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
When you are done, the appliance should not slide on the channel bar.
Installing the Accessories
2-13