Creating The Service Account - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Initial Configuration Tasks

Creating the Service Account

Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-12
Table 10-1 Sensing Interfaces
IDS Platform
IDS-4210
IDS-4215
IDS-4215-4FE
IDS-4220 and IDS-4230
IDS-4235
IDS-4235-4FE
IDS-4250
IDS-4250-SX
IDS-4250-XL
IDS-4250-4FE
IDSM-2
IPS-4240
IPS-4255
NM-CIDS
You can create a service account for TAC to use during troubleshooting. Although
more than one user can have access to the sensor, only one user can have service
privileges on a sensor. The service account is for support purposes only.
Do not make modifications to the sensor through the service account except under
the direction of TAC. If you use the service account to configure the sensor, your
configuration is not supported by TAC. Adding services to the operating system
through the service account affects proper performance and functioning of the
other IDS services. TAC does not support a sensor on which additional services
have been added.
Chapter 10 Configuring the Sensor Using the CLI
Sensing Interface
int0
int0
int0, int2, int3, int4, int5
int0
int0
int0, int2, int3, int4, int5
int0
int0, int2
int0, int2, int3
int0, int2, int3, int4, int5
int7 and int8
int0, int1, int2, int3
int0, int1, int2, int3
int1
78-15597-02