Installing The Power Supply - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 5 Installing the IDS-4235 and IDS-4250
Step 1
Step 2

Installing the Power Supply

Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Figure 5-3 Cisco Bezel
To install and remove the bezel on the IDS-4235 or IDS-4250, follow these steps:
To insert the bezel in the appliance, follow these steps:
a. Align the right side tab on the bezel with the slot on the appliance mounting
tab.
b. Press the left side of the bezel into place on the appliance.
To remove the bezel, press the left side tab and pull.
You can install a second, redundant power supply and power-supply cooling fan
(part number IDS-PWR=) in your appliance.
Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when performing the following steps.
Installing the Accessories
5-13