Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 181

Chapter 8 Installing the IDSM-2
Caution Do not touch the printed circuit boards or connector pins.
Step 6 Carefully pull the IDSM-2 straight out of the slot, keeping your other hand under
the carrier to guide it.
Note
Place the IDSM-2 on an antistatic mat or antistatic foam.
Step 7
If the slot is to remain empty, install a filler plate (part number 800-00292-01) to
Step 8
keep dust out of the chassis and to maintain proper airflow through the module
compartment.
Warning Blank faceplates and cover panels serve three important functions: they
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Keep the IDSM-2 at a 90-degree orientation to the backplane (horizontal
to the floor).
Installation and Removal Instructions
8-15