Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 304

IDSM-2 Configuration Tasks
Configuration Commands
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-108
The following configuration commands are all performed in either global
configuration mode, interface configuration mode, or VACL configuration
submode:
Global configuration mode
•
– clock calendar valid
Sets the current calendar time as the switch time on bootup.
clock summer-time zone recurring
–
Sets the switch to use the summertime settings.
clock timezone zone offset
–
Sets the timezone for the switch/IDSM-2.
– intrusion-detection module module_number management-port
access-vlan access_vlan_number
Configures the access vlan for the IDSM-2 command and control port.
intrusion-detection module module_number data-port
–
data_port_number capture allowed-vlan allowed_capture_vlan(s)
Configures the VLAN(s) for VACL capture.
– intrusion-detection module module_number data-port
data_port_number capture
Enables VACL capture for the specified IDSM-2 data port.
– ip access-list extended word
Creates access lists for use in the VACL maps.
– monitor session session {destination {interface interface
interface-number} [ , | -] {vlan vlan-id}}
Sets the destination for a SPAN session.
monitor session session {source {interface interface interface-number}
–
| {vlan vlan-id}} [ , | - | rx | tx | both]
Sets the sources for a SPAN session.
no power enable module slot_number
–
Shuts down the IDSM-2 and removes power.
Chapter 10 Configuring the Sensor Using the CLI
78-15597-02