Removing A User - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI
Step 3
Step 4

Removing a User

Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Specify the parameters for the user:
sensor(config)# username
administrator/operator/viewer
A valid username contains 1-32 alphanumeric characters. You can also use an
underscore (_) or dash (-) in the username.
For example, to add the user "tester" with a privilege level of administrator and
the password "testpassword," type the following command:
sensor(config)# username tester privilege administrator
Enter Login Password: *****
Re-enter Login Password: *****
Note If you do not specify a privilege level for the user, the user is assigned the
default viewer privilege.
Verify that the user has been added:
a. Exit configuration mode:
sensor(config)# exit
b. View a list of all users:
sensor# show users all
A list of users is displayed.
You can delete a user and thus prevent access to the sensor.
To remove a user, follow these steps:
Log in to the CLI using an account with administrator privileges.
Enter configuration mode:
sensor# configure terminal
username password
password
Sensor Initial Configuration Tasks
privilege
10-17