Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 319

Chapter 10 Configuring the Sensor Using the CLI
e.
f.
g.
Set TFTP as the transfer method:
Step 13
a.
b.
c.
Step 14 Reimage the hard-disk drive:
a.
b.
c.
d.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Type y to continue:
Ready to begin
Are you sure? y/n
You receive the following message:
The authenticity of host 10.1.2.10 (10.1.2.10) can't be
established. RSA key fingerprint is
7b:90:3b:16:5f:a1:34:92:ff:94:54:19:82:dc:73:ba. Are you sure you
want to continue connecting (yes/no)?
Type yes.
Specify the server password:
user@ip_address password
./
./ptable
.....
Disk restore was successful
The operation was successful.
Writing kernel signature to boot flash device
Read 174 bytes from vmlinuz-2.4.18-5-module.u64md5
bflash-write: After bfwrite The operation was successful
You are returned to the main menu with the
Continue with Step 15.
Type 5.
Type 2 to change to TFTP.
Type r to return to the Main menu.
Type 1.
Type the TFTP server IP address.
Type the full pathname of recovery image:
full pathname of recovery image: /path /NM-CIDS-K9-a-4.1-1-S42.bin
Type y to continue.
Ready to begin
Are you sure? y/n
Reimaging Appliances and Modules
Selection [1234rh]:
prompt.
10-123