Installing The Ids-4215; Front And Back Panel Features - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Front and Back Panel Features

Front and Back Panel Features
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-2
Removing and Replacing the IDE Hard-Disk Drive, page 3-17
•
• Removing and Replacing the Compact Flash Device, page 3-21
Removing and Installing the 4FE Card, page 3-25
•
This section describes the IDS-4215 front and back panel features and indicators.
Figure 3-1 shows the front view of the IDS-4215.
Figure 3-1 IDS-4215 Front Panel Features
POWER ACT NETWORK
Table 3-1 describes the front panel indicators on the IDS-4215.
Table 3-1 Front Panel Indicators
Indicator Description
POWER Lights up when power supply is running.
ACT Lights up when the unit has completed power-up self-test
and has started the operating system and application
software loading process.
NETWORK Blinks when network traffic is passing over either of the two
built-in Ethernet ports; does not indicate traffic on any of the
four ports of the 4FE card.
Chapter 3

Installing the IDS-4215

CISCO IDS-4215
Intrusion Detection Sensor
78-15597-02