Replacing The Hard-Disk Drive - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Removing and Replacing the IDE Hard-Disk Drive

Replacing the Hard-Disk Drive

Step 1
Step 2
Step 3
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-20
To replace the hard-disk drive in the IDS-4215, follow these steps:
Place the appliance in an ESD-controlled environment.
See Working in an ESD Environment, page
Align the hard-disk drive connector with the two guide pins on the riser card.
Push the hard-disk drive straight into the riser card connector. Do not lift or
wiggle the hard-disk drive side to side. Push carefully until the hard-disk drive is
seated.
Chapter 3 Installing the IDS-4215
1-21, for more information.
Hard
drive
78-15597-02