Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 34

Appliances
To set up a Cisco terminal server with RJ-45 or hydra cable assembly connections,
follow these steps:
Step 1 Connect to a terminal server using one of the following methods:
•
•
Configure the line/port on the terminal server as follows:
Step 2
a.
b.
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
1-10
For the IDS-4215, IPS-4240, and IPS-4255:
– For RJ-45 connections, connect a 180/rollover cable from the console
port on the appliance to a port on the terminal server.
– For hydra cable assemblies, connect a straight-through patch cable from
the console port on the appliance to a port on the terminal server.
For all other appliances, connect the M.A.S.H. adapter (part number
29-4077-01) to COM1 on the appliance and:
– For RJ-45 connections, connect a 180/rollover cable from the M.A.S.H.
adapter to a port on the terminal server.
– For hydra cable assemblies, connect a straight-through patch cable from
the M.A.S.H. adapter to a port on the terminal server.
In enable mode, type the following configuration, where # is the line number
of the port to be configured:
config t
line #
login
transport input all
stopbits 1
flowcontrol hardware
speed 9600
exit
exit
wr mem
If you are configuring a terminal server for an IDS-4215, IPS-4240, or
IPS-4255, skip to Step 3.
Otherwise, for all other supported appliances, to direct all output to the
terminal server, log in to the IDS CLI and type the following commands:
sensor# configure terminal
sensor(config)# display-serial
Chapter 1 Introducing the Sensor
78-15597-02