Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 314

Reimaging Appliances and Modules
Step 4 Select the interface port number to be used for the TFTP download:
rommon> interface <port_number>
Set an IP address for the local port on the IDS-4240:
Step 5
rommon> ip_address <ip_address>
Note
Set the TFTP server IP address:
Step 6
rommon> server <ip_address>
Step 7 Set the gateway IP address:
rommon> gateway <ip_address>
Step 8 Type set and press Enter to verify the network settings.
Step 9 Verify that you have access to the TFTP server by pinging it from your local
defined Ethernet port using one of the following commands:
rommon> ping <ip_address>
rommon> ping server
Note
Step 10 Download and install the system image:
rommon> tftp
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-118
Port—Ethernet interface port used for sensor management
•
• VLAN—VLAN ID number (leave as 0)
Image—System image file path/name
•
Select an unused IP address on the sensor's local network that can access
the TFTP server.
You can type the sync command to store these settings in NVRAM so they
are maintained across boots. Otherwise, this information must be typed
each time you want to boot an image from ROMMON.
Chapter 10 Configuring the Sensor Using the CLI
78-15597-02