Logging In To The Sensor - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Sensor Initial Configuration Tasks

Logging in to the Sensor

Step 1
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-14
To log in to the sensor, follow these steps:
Do one of the following:
a. SSH or Telnet to the appliance:
user@ip_address
ssh
ip_address
telnet
b. SSH, Telnet, or console log in to the IDSM-2:
For Catalyst Software:
–
ip_address
ssh
slot_number
session
ip_address
telnet
slot_number
session
Console>(enable) session
– For Cisco IOS software:
ip_address
ssh
slot_number
session
ip_address
telnet
slot_number
session
Router# session slot
c. SSH or Telnet to the NM-CIDS:
ip_address
ssh
service-module IDS-Sensor
ip_address
telnet
service-module IDS-Sensor
Chapter 10 Configuring the Sensor Using the CLI
slot_number
processor 1
processor 1
slot_number
processor
slot_number
/0 session
slot_number
/0 session
processor_number
78-15597-02