Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 164

Installation and Removal Instructions
Removing the NM-CIDS Offline
Step 1
Step 2
Step 3
Step 4
WO
SERIA L
ASY NC
15
11
14
10
13
9
ETH ERN ET 0
12
8
15
11
14
10
13
9
12
8
Step 5
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
7-12
You must turn off all power to the router before removing the NM-CIDS.
To remove the NM-CIDS from the router chassis, follow these steps:
Prepare the NM-CIDS to be powered off by entering:
Router# service-module IDS-Sensor
Trying 10.10.10.1, 2129 ... Open
Wait for the shutdown message before continuing with Step 2:
%SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown
complete
Turn OFF electrical power to the router.
To channel ESD voltages to ground, do not unplug the power cable.
Unplug the command and control network interface cable from the NM-CIDS.
Loosen the two captive screws holding the NM-CIDS in the chassis slot.
ASY NC 24-3 1
7
3
ASY NC 16-2 3
6
2
5
1
4
0
ASY NC 8-15
7
3
ASY NC 0-7
6
2
5
1
4
0
Network module
Slide the NM-CIDS out of the slot.
Either install a replacement NM-CIDS (see
Note
Offline, page 7-7, for the procedure) or install a blank panel (see
Network Module Panels, page
slot_number
EN
Router
7-14, for the procedure).
Chapter 7 Installing the NM-CIDS
/0 shutdown
Installing the NM-CIDS
78-15597-02
Blank