Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 128

Installing the Accessories
Step 6
Step 7
Figure 5-9 Installing the Cable-Management Arm
Step 8
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-30
Open the wire covers on the cable-management arm by lifting the center of the
wire over the top of the embossed round button on the front of the forward part of
the arm, and lifting the wire over the top of a similar round button on the back part
of the arm.
The wire cover swings open to enable cables to be routed within the arm.
Route the status-indicator end of the cable assembly through the
cable-management arm, and install the indicator in its slot at the back end of the
cable-management arm (see
Connect the power cords to their receptacles on the back panel.
Chapter 5
Figure 5-9).
Installing the IDS-4235 and IDS-4250
78-15597-02