Recommended Keyboards And Monitors - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Recommended Keyboards and Monitors

Recommended Keyboards and Monitors
Note
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
4-4
Table 4-3 describes the appearance of the SMC NIC indicators.
Table 4-3 SMC NIC Indicators
Indicator Color
LNK Green
T/R Amber
100 Green
FDX Amber
Some keyboards and monitors are not compatible with the IDS-4220 and
IDS-4230. This incompatibility could cause them to boot improperly.
You can also use a serial cable to connect to the appliance's console port.
The following keyboards and monitors have been tested with the IDS-4220 and
IDS-4230:
Keyboards
•
– KeyTronic E03601QUS201-C
KeyTronic LT DESIGNER
–
Monitors
•
– MaxTech XT-7800
Dell D1025HT
–
Chapter 4
Status
Lights up to indicate a valid 10BASE-T,
100BASE-TX, or 100BASE-FX link; off when power
is off or connection is not valid.
Blinks to indicate the network card is transmitting or
receiving data.
Lights up to indicate a 100 Mbps connection to the
network card.
Lights up to indicate the network card is operating in
full-duplex mode.
Installing the IDS-4220 and IDS-4230
78-15597-02