Reimaging Appliances And Modules; Reimaging The Appliance - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Reimaging Appliances and Modules

Reimaging Appliances and Modules

Reimaging the Appliance

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-110
This section provides procedures for reimaging the sensor image. When you
reimage the sensor, all accounts are removed and the default cisco account is reset
to use the default password "cisco". After reimage, you must initialize the sensor
again. See Initializing the Sensor, page
After you initialize your sensor, upgrade your sensor with the most recent
signature updates and service packs. See
for the procedure.
You must also reassign the interfaces. See
Interface, page 10-9, for the procedure.
This section contains the following topics:
Reimaging the Appliance, page 10-110
•
• Reimaging the NM-CIDS Application Partition, page 10-119
Reimaging the IDSM-2, page 10-124
•
When you use the recover command, you are booting to the recovery partition,
which automatically reimages the application partition on your appliance. You
can use the upgrade command to download and install a recovery partition image,
which reimages the recovery partition. You can also install the system image on
the IDS-4215, IPS-4240, or IPS-4255 by using the ROMMON to TFTP the system
image onto the compact flash device. Installing the system image reimages both
the recovery partition and application partition.
This section contains the following topics:
• Recovering the Application Partition Image, page 10-111
Upgrading the Recovery Partition Image, page 10-112
•
• Installing the IDS-4215 System Image, page 10-113
Installing the IPS-4240 and IPS-4255 System Image, page 10-116
•
Chapter 10 Configuring the Sensor Using the CLI
10-2, for the procedure.
Obtaining Cisco IDS Software, page
Assigning and Enabling the Sensing
9-1,
78-15597-02