Installing Front Mount Brackets - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 2 Installing the IDS-4210
Step 7

Installing Front Mount Brackets

Note
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Secure the appliance to the rack using a screw through the mounting bracket to
the front of the left and right posts (see
Make sure you have the following supplies (found in the front mount bracket
assembly kit) and tools to install the front mount brackets in a two-post,
open-frame relay rack:
• Two chassis support brackets
Two rack-mounting brackets
•
Six screws
•
• #2 Phillips screwdriver
The front mount bracket assembly is not intended for use as a slide rail system.
The server must be firmly attached to the rack, as shown in
page 2-12.
Installing the Accessories
Figure 2-2 on page 2-10).
Figure 2-3 on
2-11