Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 387

Appendix B Troubleshooting
MainApp 2003_Oct_10_11.16
AnalysisEngine 2003_Oct_10_11.16
Authentication 2003_Oct_10_11.16
Logger 2003_Oct_10_11.16
NetworkAccess 2003_Oct_10_11.16
TransactionSource 2003_Oct_10_11.16
WebServer 2003_Oct_10_11.16
CLI 2003_Oct_10_11.16
Upgrade History:
* IDS-K9-min-4.1-1-S47
IDS-K9-sp-4.1-3-S61.rpm.pkg
Recovery Partition Version 1.2 - 4.1(1)S47
Step 3
Step 4
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
(Release)
(Release)
(Release)
(Release)
(Release)
(Release)
(Release)
(Release)
12:00:00 UTC Thu Jun 30 2005
14:14:55 UTC Fri Feb 20 2004
If the Web server is not running, follow these steps:
Run diagnostics, save the output, and send the output file to the TAC.
a.
See Displaying Tech Support Information, page
b. Restart the Web server:
sensor# reset
Warning: Executing this command will stop all applications and
reboot the node.
Continue with reset?:yes
Request Succeeded.
sensor#
The reset command shuts down the applications running on the
Note
sensor, reboots the appliance, and restarts all the applications.
If the Web server is still running, verify that the firewall has an open port for the
sensor.
Troubleshooting the 4200 Series Appliance
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
2003-10-10T11:01:13-0500
10-31, for the procedure.
Running
Running
Running
Running
Running
Running
Not Running
B-9