Removing And Replacing The Compact Flash Device; Removing The Compact Flash Device - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 3 Installing the IDS-4215
Step 4
Step 5

Removing and Replacing the Compact Flash Device

Warning
Caution

Removing the Compact Flash Device

Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Tighten the two captive screws.
Replace the chassis cover.
See Replacing the Chassis Cover, page
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when removing and replacing the
compact flash.
This section describes how to remove and replace the compact flash device in the
IDS-4215.
This section contains the following topics:
Removing the Compact Flash Device, page 3-21
•
• Replacing the Compact Flash Device, page 3-23
To remove the compact flash device from the IDS-4215, follow these steps:
Log in to the CLI.
Prepare the appliance to be powered off:
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Removing and Replacing the Compact Flash Device
3-15, for the procedure.
3-21