Reimaging The Idsm-2 - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Reimaging Appliances and Modules
Step 15
Step 16

Reimaging the IDSM-2

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
10-124
You receive the following message:
The authenticity of host 10.1.2.10 (10.1.2.10) can't be
established.
RSA key fingerprint is
7b:90:3b:16:5f:a1:34:92:ff:94:54:19:82:dc:73:ba.
Are you sure you want to continue connecting (yes/no)?
Type yes.
e.
Reboot the NM-CIDS:
Selection [1234rh]: r
About to exit and reset Services Engine.
Are you sure? [y/N]
Type y to reboot.
You must initialize your NM-CIDS with the setup command. See
Sensor, page 10-2.
If your application partition becomes unusable, you can reimage it from the
maintenance partition. After you reimage the application partition of the IDSM-2,
you must initialize the IDSM-2 using the setup command.
See Initializing the Sensor, page
When there is a new maintenance partition image file, you can reimage the
maintenance partition from the application partition.
This section describes how to reimage the application partition and maintenance
partition for Catalyst software and Cisco IOS software.
This section contains the following topics:
• Reimaging the IDSM-2, page 10-125
Reimaging the Maintenance Partition, page 10-127
•
Chapter 10 Configuring the Sensor Using the CLI
10-2, for the procedure.
Initializing the
78-15597-02