Removing The Nm-Cids; Removing The Nm-Cids Offline; Removing The Nm-Cids Using Oir Support - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 7 Installing the NM-CIDS
Step 5
Step 6
Step 7
Step 8

Removing the NM-CIDS

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Category 5
or UTP cable
Verify that the NM-CIDS indicators light up, and that the Active/Ready indicators
on the front panel also light up.
Initialize the NM-CIDS.
See Initializing the Sensor, page
Upgrade your NM-CIDS to the latest Cisco IDS software.
See Obtaining Cisco IDS Software, page
Assign the interfaces.
See Assigning and Enabling the Sensing Interface, page
You are now ready to configure intrusion detection on your NM-CIDS.
This section contains the following topics:
• Removing the NM-CIDS Offline, page 7-12
Removing the NM-CIDS Using OIR Support, page 7-13
•
NM-CE- BP
DISK
LINK
ACT
EN
PWR
FastEther net 0
Fast Ethernet
RJ-45
10-2, for the procedure.
9-1, for the procedure.
Installation and Removal Instructions
CF
Fast Ethernet hub
10-9, for the procedure.
7-11