Supported Idsm-2 Configurations - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 8 Installing the IDSM-2

Supported IDSM-2 Configurations

Table 8-2 Supported Configurations
Supervisor
Supervisor 1A
Supervisor 1A with PFC1
Supervisor 1A with PFC1 or
MSFC1
Supervisor 1A-PFC2 or
MSFC2
Supervisor 2 with PFC2
Supervisor 2 with PFC2 or
MSFC2
Supervisor 720 (integrated
PFC3 and MSFC3)
1. VACL blocking by the IDSM-2 is supported on Catalyst software and not on Cisco IOS for this configuration.
2. Cisco IOS is supported on Supervisor 1A with PFC1 or MSFC1; however, the IDSM-2 is not supported on this configuration.
3. VACL blocking by the IDSM-2 is supported on Catalyst software and not on Cisco IOS for this configuration.
4. VACL blocking by the IDSM-2 is supported on Catalyst software and not on Cisco IOS for this configuration.
5. Supervisor 720 with Cisco IOS supports VACL deny statements; however, the IDSM-2 cannot block with Cisco IOS-style
VACLs
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Table 8-2 lists the supported configurations for the IDSM-2.
SPAN/ VACL
RSPAN Capture
X
X X
X X
X X
X X
X X
X X
The Supervisor 1A with PFC2 combination is not supported. Supervisor 2 alone
(without PFC2 or MSFC2) is not supported by Catalyst software or Cisco IOS
software.
VACL RACL
Blocking Blocking
X
1
X X
3
X X
X
4
X X
5
X
Supported IDSM-2 Configurations
Catalyst Cisco IOS
Software Software
7.5(1)
7.5(1)
2
7.5(1)
7.5(1) 12.1(19)E1
7.5(1)
7.5(1) 12.1(19)E,
12.2(14)SY
12.2(14)SX1
8-3