Reimaging The Maintenance Partition - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 10 Configuring the Sensor Using the CLI
Step 8
Step 9
Step 10
Step 11
Step 12

Reimaging the Maintenance Partition

Catalyst Software
Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Type y to continue.
When the application partition file has been installed, you are returned to the
maintenance partition CLI.
Exit the maintenance partition CLI and return to the switch CLI.
Reboot the IDSM-2 to the application partition:
cat6k# hw-module module
Verify that the IDSM-2 is online and that the software version is correct and that
the status is :
ok
module_number
cat6k# show module
Session in to the IDSM-2 application partition CLI:
cat6k# session slot
Initialize the IDSM-2.
See Initializing the Sensor, page
This section contains the following topics:
• Catalyst Software, page 10-127
Cisco IOS Software, page 10-128
•
To reimage the maintenance partition, follow these steps:
Obtain the maintenance partition file from Software Center on Cisco.com and
copy it to an SCP or FTP server.
See Obtaining Cisco IDS Software, page
Software Center on Cisco.com.
Log in to the IDSM-2 CLI.
module_number
reset hdd:1
slot_number
processor 1
10-2, for the procedure.
9-1, for instructions on how to access the
Reimaging Appliances and Modules
10-127