Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 46

Working in an ESD Environment
Connect the work surface to the chassis using a grounding cable and alligator clip.
Step 4
Caution Always follow ESD-prevention procedures when removing, replacing, or
repairing components.
Note
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
1-22
100 Mbps Link
FDX 100 Mbps Link FAILOVER
FDX
10/100 ETHER NET 0/0
10/100 ETHER NET 0/0
CONSO LE
If you are upgrading a component, do not remove the component from the
ESD packaging until you are ready to install it.
Chapter 1 Introducing the Sensor
Copper foil
78-15597-02