Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 165

Chapter 7 Installing the NM-CIDS
Removing the NM-CIDS Using OIR Support
Caution
Step 1
Step 2
Step 3
VOICE
2V
V1
SERIA L
4T
SERI AL 3
SERI AL 2
SERI AL 1
CN/LP RXC RXD
TXC TXD
CN/LP RXC
RXD TXC
TXD
CN/LP RXC RXD
TXC TXD
Step 4
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Cisco 3660 and Cisco 3700 series routers support OIR with similar modules only.
If you remove an NM-CIDS, install another NM-CIDS in its place.
To remove an NM-CIDS with OIR support, follow these steps:
Prepare the NM-CIDS to be powered off by entering:
Router# service-module IDS-Sensor
Trying 10.10.10.1, 2129 ... Open
Wait for the shutdown message before continuing with Step 2:
%SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown
complete
Unplug the command and control network interface cable from the NM-CIDS.
Loosen the two captive screws holding the NM-CIDS in the chassis slot.
HIGH SPEED SERIA L
VIC
1HSSI
FXS
1
SEE MANUAL BEFORE INSTALL
0
ATION
V0
EN
ETHERN ET
4E
ETH 3
SERI AL 0
EN
CN/LP RXC
RXD TXC
TXD
Slide the NM-CIDS out of the slot.
slot_number
H
ETH 2
ETH 1
ETH 0
3 2 1
0
LINK
ACT
Installation and Removal Instructions
/0 shutdown
7-13