Removing The Hard-Disk Drive - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Removing and Replacing the IDE Hard-Disk Drive

Removing the Hard-Disk Drive

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
3-18
This section describes how to remove and replace the IDE hard-disk drive.
This section contains the following topics:
Removing the Hard-Disk Drive, page 3-18
•
• Replacing the Hard-Disk Drive, page 3-20
To remove the hard-disk drive from the IDS-4215, follow these steps:
Log in to the CLI.
Prepare the appliance to be powered off:
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
You can also power down the sensor using IDM or IDS MC.
Note
Power off the appliance.
Remove the power cord and other cables from the appliance.
Place the appliance in an ESD-controlled environment.
See Working in an ESD Environment, page
Remove the chassis cover.
See Removing the Chassis Cover, page
Loosen the two captive screws from the hard-disk drive carrier.
Chapter 3 Installing the IDS-4215
1-21, for more information.
3-13, for the procedure.
78-15597-02