Verifying The Version Of The Idsm-2 And Nm-Cids 4.1(4) Images - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Troubleshooting the 4200 Series Appliance

Verifying the Version of the IDSM-2 and NM-CIDS 4.1(4) Images

Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
B-42
Not modifying the prompt only applies to versions before 4.1(4).
Note
You must use the Windows FTP server setup option to emulate UNIX file
•
structure and not MS-DOS file structure.
If you are using SCP, make sure you have added the SSH host key to the
•
known hosts list.
See Adding Known Hosts to the SSH Known Hosts List, page
procedure.
Try the manual upgrade command before attempting the automatic update. If it
works with the upgrade command and does not work with the automatic update,
try the following:
• Determine which IDS software version your sensor has (see
Current Version, page
Version 4.0(1) has a known problem with automatic update. Upgrade
manually to 4.1(1) before trying to configure and use automatic update.
Make sure the passwords configured for automatic update. Make sure they
•
match the same passwords used for manual update.
Make sure that the filenames in the FTP server are exactly what you see on
•
Downloads on Cisco.com. This includes capitalization.
Some Windows FTP servers allow access to the file with the incorrect
capitalization but the sensor ultimately rejects the file because the name has
changed.
• If necessary, run tcpDump on automatic update. You can compare the
successful manual update with the unsuccessful automatic update and
troubleshoot from there.
The 4.1(4) application partition files for the IDSM-2 and the NM-CIDS have been
repackaged. The following new files exist:
• IDSM-2—WS-SVC-IDSM2-K9-a-4.1-4-S91a.bin.gz
NM-CIDS—NM-CIDS-K9-a-4.1-4-S91a.bin
•
B-57, for the procedure).
Appendix B Troubleshooting
10-19, for the
Displaying the
78-15597-02