Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 120

Installing the Accessories
Step 5
Step 6
Replacing the SCSI Hard-Disk Drive
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
5-22
Open the hard-disk drive handle to release the drive.
Slide the hard-disk drive out until it is free of the drive bay.
To replace the SCSI hard-disk drive, follow these steps:
Log in to the CLI.
Prepare the appliance to be powered off:
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
You can also power down the sensor from IDM or IDS MC.
Note
Power off the appliance by pressing the power button.
Remove the front bezel.
See Installing and Removing the Bezel, page 5-12
Open the hard-disk drive handle.
Insert the hard-disk drive into the drive bay.
Close the hard-disk drive handle to lock the drive into place.
Power on the appliance by pressing the power button.
Replace the front bezel.
See Installing and Removing the Bezel, page 5-12
Replacement drives are shipped without an image. You must reimage the
Note
hard-disk drive. See
information.
Chapter 5
Reimaging the Appliance, page
Installing the IDS-4235 and IDS-4250
for the procedure.
for the procedure.
10-110, for more
78-15597-02