Chapter 4 Installing The Ids-4220 And Ids-4230 - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Installing the IDS-4220 and IDS-4230
This chapter describes the IDS-4220 and IDS-4230 and how to install them. It also
describes the accessories and how to install them.
You must upgrade the memory on the IDS-4220 to a minimum of 512 MB before
Note
you can install the most recent Cisco IDS software version. See
Memory, page
If you are upgrading an IDS-4220-E or IDS-4230-FE appliance to 4.x software,
Note
you must swap the command and control interface cable with the sensing interface
cable before you upgrade the software. See
IDS-4230-FE to 4.x Software, page
This chapter contains these sections:
•
•
•
•
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
2-3, for more information.
Front and Back Panel Features, page 4-2
Recommended Keyboards and Monitors, page 4-4
Upgrading the IDS-4220-E and IDS-4230-FE to 4.x Software, page 4-5
Installing the IDS-4220 and IDS-4230, page 4-6
C H A P T E R
Upgrading the IDS-4220-E and
4-5, for more information.
4
Upgrading the
4-1