Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual page 137

Chapter 5 Installing the IDS-4235 and IDS-4250
Flush-Mount Installation
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
To install the flush-mount brackets, follow these steps:
Locate the two slide assemblies and place them, side by side, on a smooth work
surface, with the front ends of the slide assemblies toward you. Position both slide
assemblies so that the center brackets are facing upward (see
page 5-40).
To prepare the slides for flush-mount installation, remove the front
Note
mounting bracket, rotate it 180 degrees, and reinstall it on the opposite
slide assembly.
Using a #2 Phillips screwdriver and an 11/32-inch wrench or nut driver, remove
two 12-24 x 0.5-inch pan-head Phillips screws, two nuts, and two shoulder
washers from each front center bracket (see
Remove the front bracket from both slide assemblies.
Place the bracket from one slide assembly onto the threaded studs on the opposite
slide assembly, with the bracket turned 180 degrees so that the mounting flange
faces forward (see Figure 5-13 on page
Secure each front center mount bracket (by its nuts and shoulder washers) and
tighten them by hand on their opposite slide assemblies using the two shoulder
washers and two nuts you removed in Step 2 (see
Join the front brackets you just installed to the bracket on the slide assembly with
the two 12-24 x 0.5-inch pan-head Phillips screws you removed in Step 2 (see
Figure 5-13 on page 5-40).
The joined bracket becomes the new extended rear bracket.
Installing the Accessories
Figure 5-13 on
Figure 5-13 on page
5-40).
Figure 5-13 on page
5-40).
5-40).
5-39