Removing And Replacing The Ide Hard-Disk Drive - Cisco IDS-4230-FE - Intrusion Detection Sys Fast Ethernet Sensor Installation And Configuration Manual

Chapter 3 Installing the IDS-4215
Step 6
Step 7

Removing and Replacing the IDE Hard-Disk Drive

Warning
Caution
Caution
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Reinstall the chassis on a rack, desktop, or table.
See Rack Mounting, page
Reinstall the network interface cables.
See Installing the IDS-4215, page
Only trained and qualified personnel should be allowed to install, replace, or
service this equipment. Statement 1030
Only use the replacement IDE hard-disk drive from Cisco. We cannot guarantee
that other hard-disk drives will operate properly with the IDS.
Be sure to read the safety warnings in the Regulatory Compliance and Safety
Information for the Cisco Intrusion Detection System 4200 Series Appliance
Sensor and follow proper safety procedures when removing and replacing the
hard-disk drive.
Removing and Replacing the IDE Hard-Disk Drive
Top panel screws (4)
100 Mbps Link
FDX
100 Mbps Link FAILOVER
FDX
10/100 ETHERN ET 0/0
10/100 ETHERN ET 0/0
CONSO LE
3-7, if you are reinstalling in a rack.
3-9, for the procedure.
3-17